Question. Where is my filter located in my Furnace?
In general the furnace filter is located inside the blower compartment.
This will vary with the installation of the Furnace. The HVAC (Heating Ventilating and Air Conditioning) contractor can install an Air clean Box, or cut a slot in the return air duct. There is a possibility that you're Furnace or Air Handle with have filters in the central return Grill. You do not want to install in both places. When changing the filters in the furnace
compartment, ALWAYS turn the power off at the main circuit breaker.
Up flow Furnace (air moving upward) Filter is located in the blower compartment (bottom door) adjacent to the cold air return. You have to remove both the top door and then the bottom door. Make sure that when you re-install the bottom door, it goes over the furnace frame so that it engages the safety switch. If not the furnace will not run.
Down flow Furnace. (air moving in downward direction) Filter is located in the upper blower compartment. Most furnaces will have a V shape filter system; the system will take 2 filters. The filters go up into the plenum in a V shape. Make sure that when you re-install the top door, it goes over the furnace frame so it engages the safety switch. If not the furnace will not run.
Horizontal Furnace. Most Horizontal Furnaces will have a slide
in Furnace rack, built into the furnace.
Air Handlers. Most Air Handlers will have a built in furnace filter rack in the unit. Note most Air Handles will have central returns, which have built in filter grills to accommodate a filter.. Check to see that you DO NOT HAVE a filter in the Air Handle and the filter grill. This will cause you reduced air flow and higher utility bills.
Note: Many customers us plastic deflectors to keep their drapes away from the floor vent and keep the warm air going across the floor. (Remember) warm air raises and cold air fall. REMOVE in the cooling season to have better cooling and lower utility bills.